Ekan® OIL 150-A
Universal water-based release agent for wooden or metal formwork
Ekan® OIL 150-A
Universal water-based release agent for wooden or metal formwork
Precast Admixtures
Features
EKAN® OIL 150-A is a synthetic form release oil that facilitates the easy removal of concrete from the formwork, helps in the easy release of trapped air on the concrete surface, and makes it easier to achieve a smooth surface. EKAN® OIL 150-A is a water-based emulsion and can be diluted with water.
Before applying EKAN® OIL 150-A, the formwork surface should be properly cleaned and the final application area should be dry. All wood or steel particles, residues, or dust must be removed from the surface.
Instructions for use
Areas of use
- Wooden, plywood, plastic, and steel formwork
- Precast and ready-mix concrete castings
- Horizontal and vertical surfaces
- White and colored concrete
Application
Dosage: 1 L per 25–50 m² of formwork surface (typical indication provided in data sheet). EKAN® OIL 150-A should be applied to clean, dry formwork in **a single thin, uniform layer**; apply by uniform spraying or with a brush/smooth roller, avoiding excess that may leave streaks. Does not cause clogging in spraying equipment.
Technical data
Appearance: Homogeneous
Color: Yellowish
Density: 0.885 ± 0.03 kg/L
Kinematic viscosity @40ºC: 29.7 mm²/s
Flash point: 212ºC
• Bulk
• 1000 kg/L plastic IBC tank
Precautions
Avoid contact with eyes and skin.
Store in the original, tightly closed container, in a dry place away from direct sunlight.
Detailed health and safety information is available in the Material Safety Data Sheet (MSDS).